The online racing simulator
Lislon Drift Challenge - Stage 3 - Judge Task
We remind you that on May 28, the third Stage of Lislon Drift Challenge will take place on the licensed S3 server LSN Drift Ground. The scheme for training is already on the track.


General rules on the track
• Leader on right side, chaser on left side of starting line.
• The last white lines are the border of the track. Curbs - outside of the track. If the track boundaries conflict with the drawn white or clip zone lines, then the drawn lines (white or yellow take precedence)
• For leader everywhere after initiation except the deac zone go to full throttle if it's possible.
• Yellow cone for orienting clip zines and outside zones, to make it more visible.

Judge Task
• Acceleration on green light.
• Bypassing the chikane, dont knock cones, drive without drifting.
• White line before initiation is a restricted line for the leader; the leader can't cross that.
• Initiation on the yellow line, after this line there should be a significant angle of the car. Before initiation do a little flip is ok. Brake will be mistake.
• The first outside zone, you need to fill it from beginning to end, the closer to the border of the track, the better.
• After outside zone 1 we going to inside and slowing down car due the angle, shut down the throttle is ok in deacc zone.
• We going to outside zone 2, you need to fill it from beginning to end, the closer to the border of the track, the better.
• After transition we get to clip zone 1, the closer to the border of the track the better.
• After transition we going close to no go zone, this zone for leader only, leader cant cross blue lines.
• And we get into touch and go zone, make show one wheel here, do not hit red pole, in pair runs chaser can hit pole.
• After that we wen to clip zone 2, the closer to the border of the track the better.
• Finish line.
Attached images
ldc stage 3 judge task.jpg

FGED GREDG RDFGDR GSFDG