Hello, I run a homemade FFB wheel based on simucube and Mige.
The FFB is On, all the time the wheel is on (except emergency stop).
I don't know if it is from the introduction on 100Hz or later but I have most of the time the same problem.
Wheel on,
LFS On
No FFB.
Then I go to option axes wheel FFB, I go down from 100Hz to 25Hz set FFB to Off (ingame) then to On and back to 100Hz.
FFB works


Wheel Off
LFS On
Wheel On
Peripherals refresh is about the same too.

I guess that sometimes if I load the extra drivers interface for the wheel then I might have directly On in LFS, so maybe it is not fully LFS issue.
But may be LFS should do my routine at init?