Recently while taking apart my G25, I noticed right after my left paddle started to misfire. I took it apart again and blew some air on the switch and now it seems to be ok. The switch seems a little used and maybe it is starting to go. I think it must be fairly straight forward to desolder and replace. My question is: Has anyone done this? and if so: Do you have a specific part number? So far I have found these that seem to resemble the logitech original switches, but not 100%

http://www.conrad.fr/microrupt ... 4_49913_840092_212408_FAS

Thanks!

they are just microswitches.
Cant remember how they mount; been a while since i took my wheel apart.
You will just have to ensure that you use the correct connectors on the switch; Normally open or normally closed contacts.
It should be a straight forward swap

Thanks for the reply.
I guess it's better to just measure it and compare. Was just wondering also if anyone had attempted this, it appears not very likely.